 |
| Glossary |
Saddle Clip Installation
use four grate clips to fasten panels up 10 feet long.
For panels longer than 10 feet, two additional clips on
each intermediate support are recommended.
Welding Clip Installation
A. Chose the bolt length depend the height of grating.
Welding bolt head on the steel support according to the
drawings.
B. Put the saddle clip fit on grating bars.
Make the grating panel steady. |
 |
Saddle Clip Installation
A. Assembly full set clips according to the drawings.
B. Turn bottom clip 90＜.
C. Slip bottom clop between grating bars.
D. Bottom clip snaps back, perpendicular to support clip.
Clip bolt should be as close to support steel as possible.
E. Saddle clip must be tightened in place by using a small
torque wrench, a calibrated power tool or ratchet.
Make the grating panel steady. |
 |
|
|
|
Self-Tap Clip Installation
A. Assembly full set clips according to the drawings.
B. Put the saddle clip fit on grating bars.
C. Tighten the self-tap bolt on the support steel.
Make the grating panel steady. |
|
|
|
|
|
|
I-Bar Material Information |
 |
| Ordering Information |
When ordering shanghai
Klemp steel bar grating be sure to specify:
1. KWA or KWB to indicate cross rod spacing (100 or 50
mm)
2. Depth and thickness of bearing bars(eg.,203,325)
3. Series 1,2 or 3 to indicate spacing of bearing bars
(30,40 or 60 mm)
4. P or S to indicate plain or serrated bearing bars
5.U,PT or G to indicate mill, Painted or hot dip galvanized
finish
6. Length of span (lenght of bearing bars)
7. Width of panel
8. Extras (trim band, toe plate, nosing, etc.)
9. Type of anchors and size
10. Shipping instructions
When areas of grating are required,submit a sketch of
the area to be covered and indicate:
1. Supporting structure
2. Edge of grating panel condition (installation clearances
from structural supports)
3.Direction of span (parallel to bearing bars)
4. Dimensions of total area of grating |
|
|
|
|
|
 |
|
 |
